Maa Mahakali Motors

Registered Office
Plot no-7,Himgiri Enclave
Near Transport Department
Burari, Delhi-110084

+91 991 023 4578

+91 931 003 4578 (Office)
mahakalimotors@rediffmail.com

HYDRO CYLINDER TESTING

The hydraulic pressure in these cylinders is in the form of hydraulic fuels that are stored under pressure in these cylinders. The energy stored in these oils is converted into motion. In a complete hydraulic system, a hydraulic motor consists of one or more hydraulic cylinders. A pump regulates the oil-flow in the hydraulic system. The pump is a part of the generator of a hydraulic system. The hydraulic cylinders initiate the pressure of the oil, which cannot be more than that required by the load.


A hydraulic cylinder consists of a cylindrical barrel, piston, and a piston rod. The piston that is placed within the barrel is connected to the piston rod. The cylinder bottom, and the cylinder head, closes the bottom and the head of the barrel respectively. The cylinder head is the side from where the piston rod exits the cylinder.



The cylinder bottom and the piston rod are mounted with mounting brackets or clevises. The piston in the hydraulic cylinder consists of sliding rings and seals. The piston rod chamber and the bottom chamber are the two chambers within the cylinder.



The piston rod starts moving outwards, as the hydraulic fluid is pumped into the bottom side of the hydraulic cylinder. In the reverse process, the hydraulic fluid is pushed back into the reservoir by the piston. The pressure in the cylinder is the ratio of unit force per unit piston area.